How do you properly prime and dispense product using a treatment pump?- Ningbo Aobang Sprayer Co.,Ltd.

To properly prime and dispense product using a treatment pump, follow these general steps:

1.Remove the Cap: Remove the protective cap or cover from the treatment pump. Some pumps may have a twist-off cap or a snap-on lid that needs to be removed.

2.Prime the Pump: Prime the pump by pressing it down several times until you see the product start to dispense. This helps remove any air from the pump and allows the product to flow smoothly.

3.Avoid Over-Priming: Be cautious not to over-prime the pump, as it may result in excess product being dispensed. Start with a few gentle pumps and observe the flow of product. Adjust the number of pumps as needed to achieve the desired amount.

4.Dispense the Product: Once the pump is primed, place your finger or hand over the opening of the pump to catch the product. Press down on the pump with steady and even pressure to dispense the desired amount of product.

5.Adjust the Pump Output: Some treatment pumps may have adjustable output settings. If applicable, check if there are different settings available to control the amount of product dispensed per pump action. Adjust it according to your preference.

6.Replace the Cap: After dispensing the product, replace the cap or cover on the treatment pump to protect it from contamination and maintain its integrity.

It's important to note that specific instructions may vary depending on the type and brand of the treatment pump. Always refer to the manufacturer's guidelines and product instructions for proper priming and dispensing techniques specific to your treatment pump.

Additionally, if you're using the treatment pump for the first time, it's recommended to check the product packaging or consult the manufacturer for any specific priming instructions or considerations related to the particular product you're using.

20/410 smooth closure with small dust cap treatment pump